Skip to content
Skip to main navigation
Skip to first column
Skip to second column
JAQ's Blog - Electronics, Microcontrollers, DEC Minicomputers, Raspberry Pi, Airplanes and other stuff....
Total: 6 results found.
Building a DLink DSL-502T Based IGate - TNC Schematic and Firmware
As mentioned elsewhere the
we use in the Igates is based on the ATMega8 based
design from Henry Carl Ott (N2RVQ). For those interested in constructing their own here is the schematic ...
DSL-502T IGate Front Panel LEDs
There are 5 LED's on the front of the DSL-502T. Not much to say about the Power LED. If the power is connected it should be lit. ...
Programming the DSL-502T IGate using “Damn Small Linux”
Items you need to get started: 1. The “Damn Small Linux” ISO from http://distro.ibiblio.org/pub/linux/distributions/damnsmall/current/current.iso burn to a CD (approx ...
Building a DLink DSL-502T Based IGate - The TNC
In addition to configuring the DLink DSL-502T routers for the IGate project we also needed a
to connect between the radio and the serial port. Our
selection was based on the following criteria: ...
Building OpenWRT for DSL502T Appliances - Removing Modules
When building OpenWRT Kamikaze 8.09.2 for the DSL502T there are a number of mobiles included by default that are important if you are using the device as a modem but unnecessary if you plan to use the ...
Building a DLink DSL-502T Based IGate
... doesn't say is that there is an onboard serial port (even provided with soldered pin headers) which is perfect (with level conversion from RS-232 to 3.3V TTL) for connect to an
. Using a DSL-502T ...
PDP8 SBC6120 FP6120
My Other Sites
Contact Andrew Quinn